Raritan PCS12 Guia do Utilizador descarregar pdf (Página 52)

Chapter 4: Install CC-SG

Note: The CC-SG V1 hardware ships with Gigabit Ethernet NIC

adaptors. As long as the NIC interfaces are using the default

auto-negotiation setting, practically any cable can successfully be used

between the interfaces and an Ethernet port. Depending on the cable,

full 1000Mbps connectivity may not be possible, but minimally you

should get 100Mbps.

Physical Connections for CC-SG G1 Units

Numbers on the diagram correspond to the step numbers in this

procedure.

1. Connect the network LAN cable to the LAN 0 port on the rear panel

of the CC-SG unit. Connect the other end of cable to the network.

2. Attach an included AC power cord to the power port 1 on the rear

panel of the CC-SG unit. Plug the other end of the cord into an AC

power outlet.

3. Connect a video monitor and keyboard using KVM cables to the

corresponding ports on the rear panel of the CC-SG unit.

3. Set IP Address of CC-SG

1. When you see the CommandCenter login prompt on the video

output, log in with the default username/password of admin/raritan.

Usernames and passwords are case-sensitive. You will be prompted

to change the local console password. You can still use

admin/raritan the first time you access CC-SG via a browser or other

client.

2. Press CTRL+X.

3. On the Operation menu, click Network Interfaces and then select

Network Interface Config.

4. The Administrator Console appears. In the Configuration field, select

DHCP or Static.

5. If you select Static, type a static IP address.

6. [Optional] Specify DNS servers, netmask, and gateway address.

7. Select Save. Please wait a few minutes as CC-SG restarts.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 69 70

Sem comentários

Raritan PCS12 Guia do Utilizador Página 52